Rubber Rebuilder is a quick repair resin, good anti-corrosion, and anti-wear performance. When your conveyor belt is broken, which can repair a small broken area and let the conveyor belt operate quickly.

Which density is 1.04-1.05g/cm3,   Tensile strength is 3-4Mpa, moreover, its high-temperature resistance can up 90°C. During the operation, which do not need special tools, after wait 20-30mins, which is ok.

• Good anti-corrosion and anti-wear performance

• Extensive chemical protection performance

• Low stimulation

• No  need  special  tools

• No environmental pollution 

How to use Quick Rubber Builder?

1. Remove outer wrapping :Open aluminium protective bag along the dotted line and remove the component plastic bag.

2. Remove clip: Remove the rubber seal and take off the clip.

3. Mix: After removing the plastic clip separating the two compartments, use the clip to move all materials from the corners of the plastic bag towards the centre.Mix the contents by kneading the bag for not less than 3 minutes.

4. Cut off any corner for convenient pouring.

5. Dispense: Pour contents into the prepared mould or unit.

NOTE: Higher temperatures accelerate the curing speed. Lower temperatures retard the curing speed.